Name of project (20 pt.)
A
Minor Project (14pt.)
-----------------------------------------------------------------------------
SUBMITTED IN PARTIAL FULFILLMENT
FOR THE AWARD OF THE
DEGREE OF (12PT.)
BACHELOR OF TECHNOLOGY (14PT.)
IN (12pt.)
MECHANICAL ENGINEERING (14pt.)
Submitted by (12pt.)
Name of student (12pt.) Roll No. (12pt.)
Under the guidance of (12pt.)
Name of Guide (12pt.)
college logo
(2006-2010) (14pt.)
college name (20pt.)
place (20pt.)
(Kurukshetra University, Kurukshetra) (14pt.)
NOTICE
MECHANICAL ENGG. DEPSARTMENT
FORMAT FOR PROJECT REPORT
1. No. of pages 50 to 80 (Text Material only)
2. Font size Chapter Heading & Title (Bold)(18pt.)
Main Heading (Bold, 16pt.)
Sub heading (bold), 14pt.
Text (no underline, 12pt.)
3. Font Style Times New Roman
4. Cover Page In proper and in given format
5. Sequences of pages
· Cover page
· Certificate
· Acknowledgement (Duly signed by the student itself & Guide)
· List of figures
· List of tables
· Notations / Nomenclatures (if any)
· Contents (with title & sub title name, number and page number)
· Chapters (The chapter should be in the given sequence)
Chapter 1 – Introduction
Chapter 2 – Literature Review
Chapter 3 – Conclusions and future scope
· References (The Reference should be given at the end of the report in alphabetical order indicating :
i. The author name
ii. The title of the paper and name of journal
iii. The name of the book and the publisher
iv. The number of the volume, page numbers, and the year of publication
v. Standard abbreviation may be used in the name of the journals
For Example:
1) Singh, S. and Shan, H.S. (2002) “Development of Magneto Abrasive flow Machining Process” International journal of Machine Tools & Manufacturing. Vol...42, 2, 2002, pp.953-959
2) Sharma, P.C. (2006),”A Text Book of Production Technology”, S.Chand & Company Ltd., New Delhi).
· Appendix (if any)
6. Page Numbering Center bottom (certificate, Acknowledge, List of Figures, List of tables, Notations/nomenclatures and Contents should numbered in lower roman); No Numbering for separator sheets. Appendices should also be numbered in lower roman but not in succession to above mentioned page numbering. It should start from onward.
7. Diagram/Figure/Tables :-
Decent coverage of the page as per image requirement with proper numbering e.g. fig. 1.1, 2.1 etc. (The caption for Diagram/Figure Must be given at the BOTTOM of the Diagram / Figure and caption for the table must be given at the TOP of the table).
8. Line spacing 1.5
9. Page Margins left – 1.5”
Right, Top & bottom – 1”
10. Indenting Justified (no tab indenting for new paragraphs)
11. Gap b/w paragraphs Double line spacing
12. Printing Single side only
13. Binding Hard Leather Bound
14. Chapter sub heading numbering e.g. 1.1, 2.1.1 etc.
15. No blanks on the pages accept at the end of the chapter.
16. Separator sheet b/w chapters mentioning chapter no. & title (colored sheet) and should also carry one transparency with each separator sheet.
17. Reports should be Leather Bound with Black Base and Golden Print on it, otherwise it will be not accepted at any cost.
Er.a.b.c.
H.O.D, (MECH. ENGG.)
Our Project work going in on chennai region kindly update the boom lift rental in bangalore member.
ReplyDelete